The metallographic cutting machine is one of the main equipment for daily maintenance. In fact, many times even if there is a serious error, the reason is very simple. It is precisely because of the neglect of daily life to the maintenance of the equipment that serious faults occur. Therefore in order to ensure the normal operation of the metallographic cutting machine, daily maintenance is very important.

The common faults of the metallographic cutting machine are: inaccurate positioning, fixture, easy to loosen, serious corrosion of the workbench, excessive impurities in the cutting fluid, poor circulation, poor cooling effect, etc., although these phenomena are not main problems, but for ten days and half a month's work, the impact is not great, but if you do not pay attention to timely treatment, it will seriously affect cutting ability, cutting quality and service life of the tool. The so-called "Rome was not built in a day", these small problems can not be ignored.

It is not difficult to solve this problem. As long as we develop such a small habit in our daily work! Ensure that the metallographic cutting machine runs well, with few faults effectively extend the service life of the equipment.

1. Clear away the debris after cutting to prevent accumulation and pollution

After each use of the metallographic cutting machine take out the storage basket containing chips and impurities, pour out the chips and impurities inside, wash it with water, and prevent accumulation and pollution.

2. Clean the cutting and operating platform to prevent rusting

Remove the water pipe and clean the entire cutting room wall and operating platform with a spray nozzle. Pay attention to cleaning all parts of cutting chamber, without any blind spots. After each cleaning, the surface of the operating platform or other parts will not stick to a large amount of cutting debris for a long time, corrosion.

3. Open all protective covers and keep good ventilation

Most of the parts of the metallographic cutting machine are metal, and it is easy to rust in humid environment for a long time. Once the electronic components get damp and rust, the control board will malfunction, so the equipment needs to be kept dry. When the metallographic machine is running, it uses a spray water curtain for cooling. After the cutting task is stopped, open all protective covers of the metallographic cutting machine, and evaporate the water the condition of natural ventilation.

4. Regularly replace the cooling lubricant to maintain good cooling effect

In the process of using the metallographic cutting machine, it easy to ignore the regular replacement of the cooling lubricant. Some equipment has not completely replaced the cooling fluid after three years of use. It just wants to see if the cooling is less. Add some to the water tank. When it accumulates, there is a thick layer of mud in the circulating water tank. Therefore, the cutting cooling effect is getting and worse.

Therefore, a special reminder: if you want to use the metallographic cutting machine every day, you need to clean and replace the cooling lubricant once a; if you often or occasionally use it, you can appropriately extend the replacement time, but not more than half a year; if you use it in summer, it is recommended not replace it within two months?-- you know!

The above daily maintenance is very simple. If you want your equipment to run well, you need to start with these daily and take good care of it. In order to keep the metallographic cutting machine in good working condition, daily maintenance is very important